Westsail Owners Alliance - Post: "W42 Mast To Compression Post Chase"
Westsail Westsail Owners Affiliation
 Important information about this site! 

Post: "W42 Mast To Compression Post Chase"

12,268 posts on 2,444 threads   •   From Mar 07, 2004 - Jan 08, 2012

How

Text Strings  

Full Phrase  

Which

All Words  

Any Word  

Where

Message Text

Text & Author  

What
Message Author Message Content   (1 of 1)
- Archived Message from Inactive Forum -

Bud Taplin
(Member)

The factory normally put a hole through the mast base and the cabintop in line with the stainless pipe used as an internal support. That hole should go all the way through to the bottom plate just under the cabin sole. The I beam should be 1-1/2" below the plate, and there should be 1-1/2" of spacers on each side between the bottom plate of the mast post and the I beam. The spacers have a gap between them to allow the wiring to come out above the beam.




Showing record #1 of 1 matching record


Showing record #1 of 1 matching record

  Forum Archive Home    Back to Previous Page   Show Posts w/ Images   Windbag Newsletter 
This site is provided as service to Westsail Owners by Jack Webb on Westsail 32, Hull #438, at http://HighSeasDrifter.net,
This site is provided as service to Westsail Owners by  Jack Webb (s/v Drifter, Westsail 32, Hull #438)