Westsail Owners Alliance - Post: "Lubrication In Tiller Box?"
Westsail Westsail Owners Affiliation
 Important information about this site! 

Post: "Lubrication In Tiller Box?"

12,268 posts on 2,444 threads   •   From Mar 07, 2004 - Jan 08, 2012


Text Strings  

Full Phrase  


All Words  

Any Word  


Message Text

Text & Author  

Message Author Message Content   (1 of 1)
- Archived Message from Inactive Forum -

Bud Taplin

Randy, I do not think having grease in there makes any difference. I recommend formica for shims because it is thin, and easily cut and glued in place. The shim should not be a small round disk, but a rectangular piece glued to the sides of the tiller that extends to the ends of the stainless steel box on the rudder. That way you get a good bearing surface to take the tiller to rudder loads.
Put in enough shim thickness to eliminate any sideplay between the tiller and rudder box. Tighten up the locknut on the tiller asttachment bolt just enough so that the tiller will stay at any place you move it, without falling back down to the lowest position.
The wood cheeks on the outside of the rudder are only cosmetic to cover the steel box.

Showing record #1 of 1 matching record

Showing record #1 of 1 matching record

  Forum Archive Home    Back to Previous Page   Show Posts w/ Images   Windbag Newsletter 
This site is provided as service to Westsail Owners by Jack Webb on Westsail 32, Hull #438, at http://HighSeasDrifter.net,
This site is provided as service to Westsail Owners by  Jack Webb (s/v Drifter, Westsail 32, Hull #438)